Your Custom Text Here

Duct Tips, Fabrication, Sheet Metal Kevin Raymond Duct Tips, Fabrication, Sheet Metal Kevin Raymond

5 Venting Issues When Installing Your New Built in Microwave

Are you installing a new built in microwave for the first time? Before you rip the box open, take a minute to make sure you have checked out the area where you will be installing the microwave first. Over the years I have helped many customers who have entered the fabrication shop looking for duct fittings needed to vent their brand new microwave oven.

Here are five of the most common venting issues they have conveyed to me.

 

Read More
Tutorials, Fabrication, Duct Tips Kevin Raymond Tutorials, Fabrication, Duct Tips Kevin Raymond

How to Assemble a Pittsburgh Seam for Sheet Metal Plenums

Have you gone to your local HVAC supply house to buy a plenum with a Pittsburgh seam that was not assembled? If you are an HVAC professional or do-it-yourselfer, more than likely you have. The purpose of this short tutorial is to show how to assemble a Pittsburgh seam in a few simple steps, with a couple simple tools.

Read More
Fabrication, HVAC, Manufacturing, Sheet Metal Kevin Raymond Fabrication, HVAC, Manufacturing, Sheet Metal Kevin Raymond

Old School Custom Trunk Duct Fabrication

Currently I am fabricating some custom transitions to marry a new heat pump system to this existing trunk duct. The customer emailed these this morning to give me an overview of what I would be hooking the new duct transitions up to. Always helpful when a customer is willing to take the time and snap a few shots of what the job looks like.

Read More

Custom Galvanized Sheet Metal Ash Box

The benefit of our fabrication shop is the ability to fabricate small numbers of custom projects for a range of products. Our main focus being HVAC custom ductwork and fittings, but we fabricate a lot of specialty items for many of our customers.

Last week I received a request through our website for a custom 15" x 15" x 15" ash box with a sliding top cover.

 

Read More