Posts filed under Fabrication

SaraSpa Rod & Gun Club Duct Fabrication

After installing the filter boxes and elbows shown in my previous post, it is now time to fabricate the next set of duct and transitions that will run up the wall. There are three total units and each will need a 90" drop. Below are the in-progress fittings lined up in a pretty little row.

image.jpg

Our next task is to cut and install the Ductmate Flange System on each section of duct for easy installation when we get to the jobsite.

Wolla!

image.jpg

We finished up a few 90 elbows with turning vanes for the job as well. Probably could have managed a better photo but I had to assist my helper uncle with that tub of screws :)...JK

 

SaraSpa Rod & Gun Club Duct Installation Photos

Here are a couple pics from our most recent duct installation at the SaraSpa Rod and Gun Club in Greenfield Center, NY.

    Installation of the Exit Air Unit ductwork and filter cabinet.

Installation of the Exit Air Unit ductwork and filter cabinet.

  Installation of Make-up Air Unit duct.

Installation of Make-up Air Unit duct.

The job has been progressing nicely with a lot of custom duct and fittings. Each section is fabricated with 24 gauge metal and secured together with the Ductmate Flanging System.

There is a light at the end of the tunnel regarding finishing up the installtion and fabrication. I hope to get all the photos gathered together and share them after the project is completed. With our move to a new fabrication shop space and other jobs, time has been at a premium. We are finally getting back to a somewhat normal schedule.


 

How Will Digital Fabrication Affect The Machines of The Future?

Will there ever be a time when machines can heal themselves? Heal may be the wrong word, but there may be a point where digital fabrication could help machines of the future fabricate their own parts.

Yesterday I was watching an extended PandoMonthly interview with Mark Suster of Upfront Ventures and the Both Sides of The Table blog. Mark is a well known venture capitalist who mainly invests in technology companies.  

 

5 Venting Issues When Installing Your New Built in Microwave

Are you installing a new built in microwave for the first time? Before you rip the box open, take a minute to make sure you have checked out the area where you will be installing the microwave first. Over the years I have helped many customers who have entered the fabrication shop looking for duct fittings needed to vent their brand new microwave oven.

Here are five of the most common venting issues they have conveyed to me.

 

Posted on October 16, 2013 and filed under Duct Tips, Fabrication, Sheet Metal.

How to Assemble a Pittsburgh Seam for Sheet Metal Plenums

Have you gone to your local HVAC supply house to buy a plenum with a Pittsburgh seam that was not assembled? If you are an HVAC professional or do-it-yourselfer, more than likely you have. The purpose of this short tutorial is to show how to assemble a Pittsburgh seam in a few simple steps, with a couple simple tools.

Old School Custom Trunk Duct Fabrication

Currently I am fabricating some custom transitions to marry a new heat pump system to this existing trunk duct. The customer emailed these this morning to give me an overview of what I would be hooking the new duct transitions up to. Always helpful when a customer is willing to take the time and snap a few shots of what the job looks like.